Sizing Guide

Find your product below. Each one shows how it is sized and links to its own calculator or size table.

  1. Take Off The Old CoverSo you can see the duct opening.
  2. Measure The OpeningEdge to edge, not the old faceplate.
  3. Order That SizeListed size equals opening size.
  4. Check The Faceplate FitsEach product says by how much.

Supply Registers

Return Air Grilles

Commercial / Office

Exterior Vents

Common Questions

My old cover measures 14 × 10. Do I order 14 × 10?

Probably not. The old cover's faceplate is larger than the hole behind it. Take the cover off and measure the opening. A cover that measures about 13¾ × 9¾ on the outside usually sits over a 12 × 8 opening.

What is the difference between a grille, a register and a diffuser?

A grille has fixed louvers and no damper, and is most often used on returns. A register has a damper you can open and close. A diffuser spreads supply air in one or more directions.

Do I need a return grille or a filter grille?

If your system's filter sits at the furnace or air handler, a plain return grille is enough. If the filter sits at the return opening in the wall or ceiling, you need a filter grille with a door.

How do I tell supply from return?

Hold a tissue near the opening with the system running. If air blows the tissue away, it is a supply. If it pulls the tissue in, it is a return.

My opening is between two listed sizes. What now?

Sizes come in fixed steps. Check the outer dimensions on the Amazon listing for the sizes either side, and pick the one whose faceplate covers your opening.